THREE SIMPLE STEPS TO BETTER PERFORMANCE WITH TEGULAR TILE !

1. INSTALL GRID, SNAP-IN TEG-TABS

Lower the wall mold by the height of the reveal. Snap Teg-Tabs in place.

2. MEASURE & MAKE ONE CUT!

Just as if you were using square edge tile.

3. INSTALL PERIMETER & FINISH

FIND OUT MORE

Yes on request, please note minimum quantities and lead times apply.

Definitely, Teg-Tab’s are designed to allow for a 45 degree angle.

Yes, match-up your grid and tile sizes and use one of the 9/16″ wall mold options.

Yes on request, please note minimum quantities and lead times apply.

Yes, check out how they perform. When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements.

No, Teg-Tabs snap into place and stay in place. Riveting may be necessary for seismic code requirements, in which case, rivet right through the tab. When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements.

Definitely, check how they perform under these conditions.

Teg-Tabs are available here on our web store, and at our premises in Toronto. Please contact us for information.

Sure. Just give us a call – we’ll set you up.